Optical characterization of reduced graphene Based composite thin films: Left- Handed Materials (Metamaterials)
Keywords:
metamaterial, electrodeposition, doping, thin film, optical properties.Abstract
Negative index material is a type of metamaterial with negative refractive index; being an artificial material, its fabrication is quite difficult, scaling up the production to meet the commercial demand is a challenge and the strong energy dissipation by metals poses another difficulty. This study employed a low cost, scalable technique (Electrodeposition) to synthesis Al and Ca doped NiO-ZnO-rGO thin films on fluorine doped tin oxide (FTO) without any complexing agents. The thin films were optically characterized using double Spectrophotometer within 300-1000 nm wavelength. Results reveal low absorption for all films but high transmittance of max. 78 % for luminum doped thin films. The incorporation of Al3+ and Ca2+ indicate the optical band gap of NiO-ZnO-rGO shifted to low energy (2.0 eV) and high energy (2.20 eV) respectively. All the composite thin films have unique features; negative refractive indexes, negative imaginary dielectric constant, and negative optical conductivity. These optical results of the films show they are novel left handed materials suitable for wider applications such as telemedicine, internet of things, transmission lines, energy storage devices, bio sensing, wearable devices etc.
References
Y Li, E. Baker, T. Reissman, C. Sun, & W. K. Liu Design of mechanical metamaterials for simultaneous vibration isolation and energy harvesting. Applied Physics Letters, (2017). 111(25).
N Suresh Kumar, KCB Naidu, P Banerjee, T Anil Babu, B Venkata Shiva Reddy. A review on metamaterials for device applications. Crystals, (2021) 11(5), 518.
C.C DuFort, and B. Dragnea. "Bio-enabled synthesis of metamaterials." Annual review of physical chemistry 61 (2010): 323-344.
H.M Saleh and A.I Hassan. Synthesis and characterization of nanomaterials for application in cost-effective electrochemical devices. Sustainability, (2023) 15(14), 10891.
A.S. Ismail, M. H. Mamat, and M. R. Mahmood ‘Aluminum-and iron-doped zinc oxide nanorod arrays for humidity sensor applications’’ Nanostructured Materials-Fabrication to Applications, 9, (2017). 167-184.
T Chanthong, W Intaratat and TN Wichean "Effect of thickness on electrical and optical properties of ZnO: Al films." Trends in Sciences 20, no. 3 (2023): 6372-6372.
L.Yao, X Wu, S Yang and Y. Zhang. "Structural and optical properties of Ca doped BiFeO3 thin films prepared by a sol-gel method." Ceramics International 43 (2017): S470-S473.
H. Mahdhi, Z.B, Ayadi, J.L. Gauffier, K. Djessas, and S. Alaya. "Effect of sputtering power on the electrical and optical properties of Ca-doped ZnO thin films sputtered from nanopowders compacted target." Optical Materials 45 (2015): 97-103.
A.I Istrate, I Mihalache, C Romanitan, O Tutunaru, S Vulpe, F Nastase, LM Veca. "Ca-doped ZnO: Al thin films: Synthesis and characterization." Coatings 11, no. 9 (2021): 1023.
T. Rattana "The Structural, morphological and optical properties of Ca doped TiO2
thin films prepared by sol-gel method." Creative Science 10, no. 1 (2018): 1-5.
Z.B Ayadi, L El Mir, J El Ghoul, K Djessas, S Alaya. "Structural and optical properties of calcium-doped zinc oxide sputtered from nanopowder target materials." Int. J. Nanoelectron. Mater 3, no. 2 (2010): 87-97.
I.Dharmadasa, and O.K Echendu. "Electrodeposition of electronic materials for applications in macroelectronic and nanotechnology-based devices." (2014): 680-691.
F.I Ezema, and M. N. Nnabuchi. "Growth and optical properties of chemical bath deposited MgCdS2 thin films." Journal of Research (Sciences). Vol. 17, no. 12 (2006): 115-126.
P.E Agbo, A. P. Nwofe, C.A. Elekwa, and N.M Nnabuchi, ‘’Comparative Study of the Optical Properties of CdZnS Deposited by Two methods’’. Journal of Ovonic Research. Vol. 12 no 3, (2016), 163 – 169.
R. Jain, A.S Lakhnot, K Bhimani, S Sharma, V Mahajani, R.A Panchal, M Kamble, F Han... "Nanostructuring versus microstructuring in battery electrodes." Nature Reviews Materials Vol. 7, no. 9 (2022): 736-746.
E.C Nwaokorongwu, N. Akpu and U.I Joseph. Growth and Optical Characterization of copper sulphide thin films by sol-gel technique." International Journal of Innovative Scientific & Engineering Technologies Research (2018). 6, no. 2: 38-44.
A.Hafdallah, F. Ynineb, M. S. Aida, and N. Attaf. "In doped ZnO thin films." Journal of Alloys and Compounds 509, no. 26 (2011): 7267-7270.
U. Caligulu, N Darcan, H Kejanli "Surface morphology and optical properties of Ca and Mn doped TiO 2 nano-structured thin films." Engineering Science and Technology, an International Journal 24, no. 6 (2021): 1292-1300.
S. Besra, "Synthesis and characterization of thin films based on functional metal oxides." PhD diss., 2023 Université Kasdi Merbah Ouargla.
M. Jayandran, M.M Haneefa, and V. Balasubramanian. "Green synthesis and characterization of Manganese nanoparticles using natural plant extracts and its evaluation of antimicrobial activity." Journal of Applied Pharmaceutical Science 5, no. 12 (2015): 105-110.
L. Dejam, S Kulesza, J Sabbaghzadeh, A Ghaderi, S Solaymani...S., ?S.,, ?., ... and Hossein Sari, A. ‘’ZnO, Cu-doped ZnO, Al-doped ZnO and Cu-Al doped ZnO thin films: Advanced micro-morphology, crystalline structures and optical properties.’’ Results in Physics, 44, (2023). 106-209.
P.E. Agbo, and P. A. Nwofe. "Structural and optical properties of sulphurised Ag2S thin films." International Journal of Thin Films Science and Technology 4, no. 1 (2015): 9-12.
S.M. Ali, W. A. Farooq, M. R. Baig, M. A. Shar, M. Atif, S. S. Alghamdi, & M. S. Algarawi, “Structural and optical properties of pure and Ag doped ZnO thin films obtained by sol gel spin coating technique,”. Mater. Sci. Poland, (2015) 33(3), 601-605.
P.A. Nwofe, and P.E Agbo. "Effect of deposition time on the optical properties of cadmium sulphide thin films." International Journal of Thin Films Science and Technology 4, no. 2 (2015): 63. S Gedi, VRM Reddy, C Park, J Chan-Wook, RR KT
S.Gedi, VRM Reddy, C Park, J Chan-Wook, and R.K.T Ramakrishna. "Comprehensive optical studies on SnS layers synthesized by chemical bath deposition." Optical Materials 42 (2015): 468-475.
S.A. Gaikwad, Y. D. Tembhurkar, and C. M. Dudhe. "Study of optical, morphological and electrical properties of CdZnSeTe thin films prepared by spray pyrolysis method." Int. J. Pure Appl. Phys 13 (2017): 339-347
S.U. Offiah, P. E. Ugwoke, A.B. C. Ekwealor, S. C. Ezugwu, R. U. Osuji, and F. I. Ezema. "Structural and spectral analysis of chemical bath deposited copper sulfide thin films for solar energy conversions." Digest Journal of Nanomaterials and Biostructures 7, no. 1 (2012): 165-173.
J.Valentine, S. Zhang, T. Zentgraf, E. Ulin-Avila, D. A. Genov, G. Bartal, and X. Zhang,
metamaterial with a negative refractive index. Nature, (2008). 455(7211), 376-379.
Cissan A. Sylvanus, Jemima N. Ogwo, Sylvanus O. Isaac (2024) Synthesis and characterization of nickel doped ternary oxide thin film as electrode materials for supercapacitor application. Engineering and Technology Journal.
http://doi.org/10.30684/etj.2024.150129.1769
A.M. Urbas, Z. Jacob, L. Dal Negro, N. Engheta, A.D. Boardman, P. Egan,... & D. Chanda,
metamaterials." Journal of Optics 18, no. 9 (2016): 093005.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2024 CISSAN SYLVANUS
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Authors who publish with this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License ( Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- To the extent transferable, copyright in and to the undersigned article is hereby assigned to Collaborating Academics and Open Access Journal Materials and Devices (ISSN: 2495-3911) for publication in the website of the journal and as part of a book (eventually a special volume) that could be produced in a printed and/or an electronic form.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
- Figures, tables, and other information present in articles published in the OAJ Materials and Devices may be reused without permission, provided the citation of original article is made in figure's or table's caption.